Menu
Cart 0

Elesa MFH Finger Handles

Posted by Jason Reigh on

Elesa MFH Finger Handles

Elesa Finger Handles are great for applications in which a standard pull handle is too large.

Material
Polyamide based (PA) technopolymer. Resistant to solvents, oils, greases and other chemical agents.

Standard Executions
Blind holes for fitting by means of no. 2 self-tapping screws for plastic materials Ø3.5 (UNI ISO 7049), not included in the supply. Maximum tightening torque of the self-tapping screws 1,2 [Nm].

- MFH-AF: in 4 standard colours: black, orange, grey, red, matte finish.
- MFH-AF-CLEAN: white colour similar to RAL 9002, matte finish. 
- MFH-CR: chrome-plated, matte finish.

Chemical agents resistance (for MFH-CR)
The chrome-plating makes the surface finish semi-glossy and homogeneous to facilitate cleaning operations. The chrome-plated surface is resistant to wear, scrapes and shocks. Laboratory tests carried out at ambient temperature (23°C) proved the resistance of the surface to: detergents, acetone, ethyl alcohol, formic acid, chlorine solutions.

Technical Data
Tensile stress and impact strength: the values F2 and L1 indicated in the table were obtained during breaking tests carried out with the appropriate dynamometric equipment under the test conditions shown in the figure with ambient temperature.

 


Share this post



← Older Post Newer Post →